Acroprint ATR240 Top Loading Time Card Recorder - Manual (Page 12)

Page 9
Re-setting Time Recorder to Factory Defaults
The "All-Reset" button on the internal control panel resets Time Recorder settings such
as date, time, print/display formats, to the factory defaults. See chart for factory defaults.
Note: The button is recessed to prevent accidentally resetting the Time Recorder settings.
Use the point of a pen or paperclip to access the button. It will take approximately 9
seconds to complete the reset.
Troubleshooting
Symptom Possible Problem Solution
Clock does
not power on
Power Outage
The power source was not properly
connected
Check circuit breaker. Wait for power to be
restored
Check the connections of the power supply
and/or backup battery
The time is
incorrect
The time was not set correctly.
Prolonged power outage.
Set correct time
Set time after power is restored
The clock
keeps losing
time
The coin cell battery on the
motherboard needs to be replaced. Replace the coin cell on the motherboard.
Display Off,
Clock has
Power Defective Motherboard
Defective LCD display
Contact Local Dealer or Acroprint for repair
The date is
incorrect The date was not set correctly Set correct date
Clock beeps
and rejects
time card
Wrong side of card is inserted
(monthly card)
Incompatible time card
Flip card over and re-insert
Use card approved for the ATR240
Print too light
Ribbon cassette not properly seated.
The print ribbon is dried out
Remove and re-insert ribbon cassette
correctly
Replace ribbon cassette
Punches print
in wrong
column
Wrong column selected (manually
selected) or column change time set
incorrectly. Select the correct column (P1 – P6) or set the
correct column change time