Acroprint ATRx Biometric 1000 - Manual (Page 4)

7 - ATRx Biometric 1000™ Installation Guide
4. Select an employee record from the list by left clicking one
time on the Last Name field.
5. Left click one time on the Enroll Hand button at the bottom
of the screen.
6. Left click one time on the Enroll Employee button.
7. Select Yes to the message Enroll for PIN and the employee
PIN displayed.
8. Message about enrolling your handprint will display.
Follow the on-screen instructions placing the employee’s
hand in the hand punch 4 times.
Successful enrollment of hand will display:
9. Select OK.
10. Select Save on the Employee Hand Punch window.
ATRx Biometric 1000™ Installation Guide - 8
NOTE
11. After completing this process, select Save in the Employee
record main window. Employees may begin using the HP1000
immediately after successful enrollment.
For instructions on preparing the HandPunch for wall mounting,
routing of wiring, and wiring connections, please refer to the
user manual on pages 15-21. Be sure to test and enroll the
employees prior to mounting the Handpunch.
Employees Instructions For Using
the Handpunch 1000
When your employees have been successfully enrolled in the
software and HP1000 they are ready to clock in/out.
1. Employee enters assigned PIN number on the keypad
of HP1000.
2. Press Enter. (red placement lights will display).
3. Place right hand into the HP1000 as shown on the front
panel of the hand punch.
4. A green light will display with a message confirming Okay
and a Read Score to let the employees know their punch
was good. *
* A Read Score reflects how accurately the employee is placing
their hand in the HP1000. Score will vary greatly. Scores above
50 indicate incorrect hand placement.
Repeat this process as needed to continue enrolling employees. Also perform
this for new hires.