Acroprint ESP180 Time Stamp - Manual (Page 8)

8 Setup
2.3 Connecting power
Before you place the ESP180 on a wall or a flat
surface, you must make sure the power is connected.
Before connecting the power cord, you must remove
the wall-mounting bracket on the back of the unit as
follows:
1. Use the key to unlock the bracket from the
bottom.
2. Insert the key into the keyhole on the bottom.
3. Turn it 1/4 turn counterclockwise.
4. Slide the bracket down and away from the unit.
5. Remove the key.
UNLOCK
BRACKET
PROGRAM
MODE
Wall Mount Bracket
Keyhole
Back of ESP180
NOTE: Please keep all the packing materials so they may be
used should you wish to transport the ESP180 in the future. They
are specifically designed to protect the ESP180 during shipment.
Key Holder