Acnodes PCH 7791 - Manual (Page 2)

PCH 7591
15 inch Atom Fanless Panel PC
© Copyright 2012 Acnodes, Inc.
All rights reserved. Product description and product specifications
are subject to change without notice. For latest product information,
please visit Acnodes’ web site at www.acnodes.com. 14628 Central Ave.
Chino, CA91710
Tel:909.597.7588, Fax:909.597.1939
PCH 7791
17 inch Atom Fanless Panel PC
Warning!
Safety & Warranty
1. Read these safety instructions c arefully.
2. Keep this user's manua l f or later reference.
3. Discon nect this equipment from any outle t before clean ing. Do not use liquid or spray
detergents for cleaning. Use a damp cloth.
4. For pluggable equipment, the p ower outlet must be installed near the equipment and must be
easily accessible.
5. Keep this equ ipment away from humidity .
6. Put this equipment on a reliable surface during installation. Dropping it o r let ting it fall could
cause damage.
7. The openings on the enc losure are for air convec tion. Protect the equipment from overheating.
DO NOT COVER THE OPENINGS.
8. Ma ke sure the voltage of the power source is correc t before co nnecting the equipment to the
power outlet.
9. All cautions and warnings on the equipment should be noted.
10 . If the equ ipment is not used for a long time, disconnect it from the power source to avoid
damage by transien t over-voltage.
11 . Never pour any liquid into an opening. This could c ause fire or electrical sh ock.
12 . NEVER OPEN THE EQUIPMENT. FOR SAFETY REASONS, ONLY QUALIFIED SERVICE
PERSONNEL SHOULD OPEN THE EQUIPMENT.
13 . If any of the following s ituations arise s, get the equipment checked by s erv ice personnel:
The power cord or plug is damaged.
Liquid ha s penetrat ed into the equipment.
The equipment has been expos ed to mo isture.
The equipment does not work well, or you c annot get it to work according to the users manual.
The equipment has been dropped and damaged.
The equipment has obvious signs of breakage.
14 . DO NOT LEAVE THIS EQ UIPMENT IN AN ENVIRO NMENT WHERE THE STORAGE
TEMPERATURE IS BELOW -20° C OR ABOVE 70° C. IT MAY DAMAGE THE EQ UIPMENT.