Candy FO FLG 203 X - Manual (Page 54)

TURNING ON THE OVEN
The oven is equipped with electric ignition. To turn on the oven, open the door
completely. Press the thermostat knob slightly and turn it counter-clockwise to the
maximum. Press the knob completely to trigger the electric ignition and keep the knob
pressed for a few seconds. However, do not activate the device for more than 15
seconds.
If the burner does not light in 15 seconds, keep the door completely open and wait at
least 1 minute before trying again.
NOTE: when the oven is turned on for the first time, it is normal to have to repeat the
operation several times due to the presence of air in the gas supply line. Once the flame
is lit, keep the thermostat knob pressed for a few seconds to activate the safety
thermocouple that would otherwise block the gas supply. Check the successful lighting
of the burner through the slots located in the front part of the oven plate; if it is not lit,
repeat the operation.
The proper operation of the burner should be checked with the oven door closed.
DURING OPERATION
Keeping the door closed, check that the cooling fan is operating properly. If the fan
does not work, proceed as follows:
1. check the power supply; if there is a power failure stop baking, turn off the
appliance and wait for power to be restored.
2. if there is no power failure, do not use the oven and contact the service centre.
If the oven door is opened during use, the fan stops to prevent the flow of hot air in the
direction of the user; once the door is closed again the fan resumes operation; if this
does not occur, perform the checks listed in points 1 and 2.
50