Candy FO FLG 203 X - Manual (Page 45)

CONNECTION TO THE GAS SUPPLY
The supply system must be compliant with the current local standards in the
country of use. The type of gas for which the oven has been regulated is indicated
on the serial number plate located on one of the side edges of the cavity (visible
with the door open) and on the packaging. Before carrying out the connection,
the oven must be adapted to the type of gas that will be used. The connection
between the gas fitting, ramp and pipe can be carried out in one of the following
ways (see drawing in fig.3):
1. Using an attachment without seals (the oven attachment is conical: ISO
R 7).
2. Using the seal provided.
Attention: when finished, check that there are no gas leaks.
Use soap and water or special liquids to make sure that there are no gas leaks.
DO NOT USE OPEN FLAMES WHEN SEARCHING FOR GAS LEAKS.
Warning:
the use of a rubber flexible hose fastened with hose clamps is
prohibited because it cannot be inspected.
Fig. 3
RAMP
SEAL
FLEXIBLE HOSE
2)
1)
41