HONDA 2011 Accord Crosstour - Manual (Page 351)

Install the new bulb and turn it
clockwise to lock it in place.
Turn on the lights to make sure
the new bulb is working.
Insert the socket back into the
headlight assembly. Turn it
clockwise to lock it in place.
Reinstall the coolant reserve tank.
Use a flat-tip screwdriver to
remove the holding clip from the
inner fender, and remove the
screw with a Phillips-head
screwdriver.
To change the bulb on the driver’s
side, start the engine, turn the
steering wheel all the way to the
right, then turn off the engine. To
change the bulb on the passenger’s
side, turn the steering wheel to the
left.
Reinstall the splash separator and
duct securely. Reinstall the
fastener and secure it by pushing
on the head until it locks.
6.
1.
7.
5.
4.
2.
Passenger’s side
Driver’s Side
Replacing a Front Side Marker
Light Bulb
Lights
348
SCREW
HOLDING CLIP
10/08/27 15:00:36 31TP6610_353
2011 Accord Crosstour