HONDA 2011 Insight - Manual (Page 307)

Insert the dipstick all the way back
into its hole.
Wipe off the dipstick with a clean
cloth or paper towel.
Remove the dipstick (orange loop).
Wait a few minutes after turning the
engine off before you check the oil.
To close the hood, lift it up slightly to
remove the support rod from the
hole. Put the support rod back into
its holding clip. Lower the hood to
about a foot (30 cm) above the
fender, then let it drop. Make sure it
is securely latched.
Holding the grip, pull the support
rod out of its clip. Insert the end
into the designated hole in the
hood.
2.
3.
1.
3.
CONTINUED
Oil Check
Service Station Procedures
B
e
fo
re
D
riv
ing
301
SUPPORT ROD CLIP
GRIP DIPSTICK
10/09/02 14:19:38 31TM8610_306