FIAT Stilo User Manual

Page 233

232

ARNING

LIGHTS AND MESSAGES

TECHNICAL

SPECIFICA

TIONS

INDEX

DASHBOARD AND CONTROLS

SAFETY DEVICES

CORRECT USE OF THE CAR

IN AN

EMERGENCY

CAR

MAINTENANCE

Changing the rear window blade

Proceed as follows:

❒ raise the cover A-fig. 24 and remove

the arm from the car, slackening the nut
B that fastens it to the pivot pin;

❒ fit the new arm, positioning it correct-

ly, and fully tighten the nut;

❒ lower the cover.

SPRAY NOZZLES

Windscreen wiper fig. 25

If the jet of fluid is inadequate, firstly check
that there is fluid in the reservoir: see
“Checking fluid levels” in this section).

Then check that the nozzle holes are not
clogged, if necessary use a needle.

The windscreen jets are directed by ad-
justing the angle of the nozzles: turn the
nozzle cylinder by inserting a screwdriv-
er in A.

Fluid jets shall be directed at about 1/3
height from the window upper edge.

Rear window wiper fig. 26-27

Rear window washer jets can be adjust-
ed in the same way.

The nozzle holder is on the rear window.

fig. 24

F0C0160m

fig. 25

F0C0163m

fig. 26

F0C0161m

fig. 27

F0C0350m