FIAT Nuovo Doblo' Panorama User Manual

Page 32

KNOW

YOUR

VEHICLE

SAFETY

STARTING

AND

DRIVING

WARNING

LIGHTS AND

MESSAGES

IN AN

EMERGENCY

SERVICING

AND

MAINTENANCE

TECHNICAL

SPECIFICATIONS

INDEX

Values displayed

Range
Shows the approximate distance the vehicle can travel with
the amount of fuel left in the tank. The display will show
the reading “----” when the following events take place:
– range is lower than 50 km (or 30 mi)
– vehicle is left parked with the engine running for a long
time.

WARNING The range can be affected by several factors:
driving style (see “Driving style” in the “Starting and dri-
ving” section), type of route (motorway, towns and cities,
mountain roads, etc.), conditions of use (load, tyre pres-
sures, etc.). Trip planning must therefore take the above
into account.

Distance travelled
Shows the distance covered since the start of the new jour-
ney.

Average consumption
Shows the approximate average fuel consumption since
the start of the new journey.

Current consumption
Shows the constantly updated fuel consumption. The read-
ing “----” appears on the display if the vehicle is parked with
the engine running.

Average speed
Shows the average speed of the vehicle by using the over-
all time elapsed since the start of a new journey.

TRIP COMPUTER

General information

The Trip computer is used to display information on ve-
hicle operation when the ignition key is turned to MAR.
This function allows you to define two separate trips, called
“Trip A” and “Trip B”, for monitoring the vehicle’s „com-
plete mission” (journey) in a reciprocally independent man-
ner. Both functions can be reset (reset – start of a new
journey).

“Trip A” is used to display the figures relating to:

– Range
– Distance travelled
– Average consumption
– Instant consumption
– Average speed
– Travel time (driving time).

“Trip B”, available on multifunction display only, is used to
display the figures relating to:
– Distance travelled B
– Average consumption B
– Average speed B
– Travel time B (driving time).

N.B. “Trip B” may be disabled (see “Activating Trip B”).
“Range” and “Instant consumption” parameters cannot be
reset.