FIAT Nuovo Doblo' Panorama - Manual (Page 165)

161
KNOW
YOUR
VEHICLE
SAFETY
STARTING
AND
DRIVING
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
SERVICING
AND
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
F0V0156m fig. 137 F0V0157m fig. 138
❒ loosen the fastening bolts completely and then remove
the wheel;
❒ make sure the contact surfaces between spare wheel
and hub are clean so that the fastening bolts will not
come loose;
❒ fit the standard wheel by inserting the first bolt two
threads B-fig 138 into the hole closest to the inflation
valve A;
❒ fit the hubcap, making sure that the symbol C aligns
with the inflation valve, and then insert the other three
bolts.
❒ tighten the bolts using the wrench provided;
❒ turn the jack handle to lower the vehicle, and remove
the jack;
❒ use the wrench provided to tighten the bolts in a criss-
cross fashion in the order shown in fig. 139.
❒ operate the jack with the handle and extend it so that
groove A-fig. 137 of the jack fits correctly onto lower
profile B on the sidemember;
❒ warn anybody nearby that the vehicle is about to be lift-
ed. They must stay clear and not touch the vehicle un-
til it is back on the ground.
❒ introduce the handle by pushing it into the hole in the
nut and into the plastic clip, operate the jack and lift the
vehicle until the wheel is a few centimetres off the
ground. When turning the crank, ensure that it rotates
freely in order to avoid grazing your hands against the
ground. The moving components of the jack (screws
and joints) can also cause injuries, so do not touch them.
Clean yourself thoroughly if you come into contact with
lubricating grease;