FIAT Sedici - Manual (Page 109)

105
Quick cooling
(using recirculated air)
The control settings are the same as for
normal cooling except you select “RE-
CIRCULATED AIR” and the highest blow-
er speed.
NOTE
❒ If you select “RECIRCULATED AIR”
for an extended period of time, the air
in the vehicle can become contaminat-
ed. Therefore, you should occasional-
ly select “FRESH AIR”.
❒ If your vehicle has been left in the sun
with the windows closed, it will cool
faster if you open the windows briefly
while you operate the air conditioner
with the air intake selector at “FRESH
AIR” and the blower at high speed.
Dehumidifying
Set the air flow selector to a desired air
flow selector position, the temperature
selector to the desired temperature po-
sition and the blower speed selector to
the desired blower speed position. Also
select “FRESH AIR” and turn on the
“A/C” switch.
NOTE Because the air conditioner dehu-
midifies the air, turning it on will help keep
the windows clear, even when blowing
heated air using the “DEFROST” or
“HEAT & DEFROST” functions.
NOTE If you need maximum defrosting:
❒ select “DEFROST” and “FRESH AIR”,
❒ turn on the “A/C” switch,
❒ set the blower speed selector to HIGH,
❒ adjust the temperature selector to the
HOT end, and
❒ adjust the side outlets so the air blows
on the side windows.
Head cooled/ Feet warmed heating
Select “BI-LEVEL” and “FRESH AIR”, the
temperature selector to the desired tem-
perature position, and the blower speed se-
lector to the desired blower speed posi-
tion. Unless the temperature selector is in
the fully COLD position or fully HOT po-
sition, the air that comes out of the cen-
ter and side outlets will be cooler than the
air that comes out of the floor outlets.
Normal cooling
Set the air flow selector to “VENTILA-
TION”, the temperature selector to the
desired temperature position and the
blower speed selector to the desired
blower speed position, and turn on the
“A/C” switch. Setting the blower speed
selector to a higher blower speed position
increases cooling efficiency.
You can switch the air intake selector to
either “FRESH AIR” or “RECIRCULAT-
ED AIR” as you desire. Choosing “RE-
CIRCULATED AIR” increases cooling ef-
ficiency.
79J070
071-130 SEDICI LUM FL GB 1ED 10-10-2011 14:31 Pagina 105