beautypg.com

FIAT Freemont User Manual

Page 205

background image

EXHAUST GAS

WARNING!

Exhaust gases can injure or kill. They
contain carbon monoxide (CO), which is

colorless and odorless. Breathing it can make you
unconscious and can eventually poison you. To
avoid breathing (CO), follow these safety tips:

Do not run the engine in a closed garage or in

confined areas any longer than needed to move your
vehicle in or out of the area.

If you are required to drive with the trunk/

liftgate open, make sure that all windows are
closed and the climate control BLOWER switch is
set at high speed. DO NOT use the recirculation
mode.

If it is necessary to sit in a parked vehicle with

the engine running,adjust your heating or cooling
controls to force outside air into the vehicle. Set
the blower at high speed.

The best protection against carbon monoxide entry
into the vehicle body is a properly maintained engine
exhaust system.

Whenever a change is noticed in the sound of the
exhaust system, when exhaust fumes can be detected
inside the vehicle, or when the underside or rear of the
vehicle is damaged, have a competent mechanic inspect

the complete exhaust system and adjacent body areas
for broken, damaged, deteriorated, or mispositioned
parts. Open seams or loose connections could permit
exhaust fumes to seep into the passenger compart-
ment. In addition, inspect the exhaust system each time
the vehicle is raised for lubrication or oil change.
Replace as required.

SAFETY CHECKS YOU SHOULD MAKE
INSIDE THE VEHICLE

Seat Belts
Inspect the seat belt system periodically, checking for
cuts, frays, and loose parts. Damaged parts must be
replaced immediately. Do not disassemble or modify
the system.

Front seat belt assemblies must be replaced after a
collision. Rear seat belt assemblies must be replaced
after a collision if they have been damaged (i.e., bent
retractor, torn webbing, etc.). If there is any question
regarding belt or retractor condition, replace the seat
belt.

Air Bag Warning Light

The light should turn on and remain on for
four to six seconds as a bulb check when the
ignition switch is first turned ON. If the light
is not lit during starting, or if the light stays

199

KNOWING

YOUR

VEHICLE

SAFETY

STARTING

AND

DRIVING

WARNING

LIGHTS

AND

MESSAGES

IN AN

EMERGENCY

SERVICING

AND

CARE

TECHNICAL

SPECIFICATIONS

CONTENTS