FIAT Bravo - Manual (Page 82)

TO RETURN THE REAR SEAT
BACK TO ITS ORIGINAL
POSITION
Move aside the seat belts, check that they
are not twisted.
Lift the seat backs and push them back-
ward until both coupling mechanisms click
in place, check that the “red band” B-fig.
92 at the side of levers A is no longer vis-
ible.
The “red band” B indicates missing seat
back coupling.
Reposition the cushions in horizontal po-
sition keeping the centre seat belt tongue
raised.
81
SAFETY DEVICES
CORRECT USE OF THE CAR
WARNING LIGHTS AND MESSAGES
IN AN
EMERGENCY
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
DASHBOARD AND CONTROLS
Total extension
Tilt the rear seat completely to obtain
maximum boot extension.
Proceed as follows:
❒ lower completely the rear seat head re-
straints;
❒ move the seat belt sideways and check
that the belt is not twisted;
❒ fold cushions forward as described pre-
viously;
❒ remove the rear parcel shelf fig. 90 and
release the upper ends A-fig. 91 of the
two tie rods by removing eyelets from
the pins and pushing them in arrow di-
rection;
❒ after tilting the cushion, fold complete-
ly rear seat backs (as described previ-
ously) to have one single surface.
fig. 91 F0Q0687m fig. 90 F0Q0686m fig. 92 F0Q0683m
Make sure the seat back is
correctly hooked on both
sides (“red bands” B-fig. 92 not visi-
ble) to prevent seat back being
thrown forwards and injuring pas-
sengers should you brake sharply.
WARNING
057-082 BRAVO GB 10-05-2007 9:09 Pagina 81