FIAT Bravo - Manual (Page 162)

161
SAFETY DEVICES
CORRECT USE OF THE CAR
W
ARNING
LIGHTS AND MESSAGES
CAR
MAINTENANCE
TECHNICAL
SPECIFICA
TIONS
INDEX
DASHBOARD AND CONTROLS
IN AN
EMERGENCY
❒ install the space-saver spare wheel
matching the holes S-fig. 7 with the
corresponding pins T;
❒ using the wrench provided, fully tight-
en the four fastening bolts;
❒ work the jack handle R-fig.6 to lower
the car and remove the jack;
❒ using the wrench provided, tighten up
the wheel bolts in a criss-cross fashion
following the sequence shown in fig. 8.
REFITTING THE STANDARD
WHEEL
Following the procedure described previ-
ously, raise the car and remove the spare
wheel.
For versions with steel rim
Proceed as follows:
❒ Make sure the contact surfaces be-
tween standard wheel and hub are
clean so that the fastening bolts will not
come loose;
❒ Fit the normal wheel matching the
holes S-fig. 7 with the corresponding
pins T;
❒ Using the wrench provided, tighten the
fastening bolts;
❒ Lower the car and remove the jack;
❒ Using the wrench provided, fully tight-
en the bolts in the sequence shown in
fig. 8;
❒ Place the cap near the wheel so that the
inflation valve can come through the
slot provided on the cap;
❒ Press the circumference of the cap,
starting from the parts nearest the in-
flation valve until it is inserted com-
pletely.
IMPORTANT Incorrect fitting may cause
the wheel cap to come off when the car is
travelling.
fig. 7 F0Q0396m fig. 8 F0Q0397m
155-190 BRAVO GB 10-05-2007 9:19 Pagina 161