FIAT Linea User Manual

Page 22

SAFETY DEVICES

CORRECT USE OF THE

CAR

ARNING

LIGHTS AND MESSAGES

IN AN

EMERGENCY

CAR

MAINTENANCE

TECHNICAL

SPECIFICA

TIONS

INDEX

DASHBOARD AND CONTROLS

Setting the speed limit (SPEEd)

This function may be used to set the car
speed limit (km/h or mph), when this lim-
it is exceeded the driver is immediately
alerted (see section “Warning lights and
messages”).

To set the speed limit, proceed as follows:

– briefly press button MENU ESC, the
message (SPEEd) and the previously set
unit (km/h) or (mph) will appear on the
display;

– press button + or – to activate (on) or
deactivate (OFF) the speed limit function;

– if the function is on, press buttons + or
– to select the required speed limit and
then press MENU ESC to confirm;

Note The speed may be set in the range
from 30 to 200 km/h, or from 20 to 125
mph according to the previously chosen
unit (see “Setting the distance unit”) de-
scribed below. The setting will in-
crease/decrease by five units each time
button +/– is pressed. Hold button +/–
pressed to increase/decrease the setting
rapidly. Complete the setting by briefly
pressing the button when you approach
the required setting.

– briefly press button MENU ESC to go
back to the menu screen or press the but-
ton for long to go back to the standard
screen without storing settings.To cancel
the setting, proceed as follows:

– briefly press button MENU ESC: (On)
will blink on the display;

– press button –: (Off) will blink on the
display;

– briefly press button MENU ESC to go
back to the menu screen or press the but-
ton for long to go back to the standard
screen without storing settings.

Setting the clock (Hour)

This function is used to set the clock.

Proceed as follows:
– briefly press button MENU ESC,
“hours” will flash on the display;
– press button + or – for setting;
– briefly press button MENU ESC, “min-
utes” will flash on the display;
– press button + or – for setting;

– briefly press button MENU ESC to go
back to the menu screen or press the but-
ton for long to go back to the standard
screen without storing settings.

Adjusting the buzzer volume
(bUZZ)

This function is used to adjust the buzzer
volume used for failure/warning indica-
tions and when MENU ESC, + and –
buttons are pressed.

To adjust the volume proceed as follows:

– briefly press button MENU ESC, the
display will show the wording (bUZZ);

– press button + or – to select the re-
quired volume (volume can be adjusted ac-
cording to 8 levels).

– briefly press button MENU ESC to go
back to the menu screen or press the but-
ton for long to go back to the standard
screen without storing settings.