FIAT Linea - Manual (Page 167)

166
W
ARNING
LIGHTS AND MESSAGES
CAR
MAINTENANCE
TECHNICAL
SPECIFICA
TIONS
IINDEX
DASHBOARD AND CONTROLS
SAFETY DEVICES
CORRECT USE OF THE
CAR
IN AN
EMERGENCY
COURTESY LIGHT fig. 33
To change the bulb proceed as follows:
❒ open the mirror cover A;
❒ extract lens B levering in the points
shown by the arrow;
❒ delicately lift the bulb holder C from its
seat, extract the clipped-on bulb and re-
place it;
❒ correctly reposition the bulb holder C
in its seat;
❒ refit the light B inserting it in its cor-
rect position firstly on one end and
then on the other until it clicks into
place.
BOOT LIGHT fig. 34
To change the bulb, proceed as follows:
❒ open the tailgate;
❒ remove the light A levering in the point
shown by the arrow;
❒ open the protection B and replace the
snap-fitted bulb;
❒ re-close the protective cover B on the
lens;
❒ refit the light A inserting it in its cor-
rect position firstly on one end and
then on the other until it clicks into
place.
PUDDLE LIGHTS
(where provided) fig. 35-36
To change the bulb, proceed as follows:
❒ remove the light by pressing clip A-fig.
35 with a screwdriver;
❒ press the bulb protection cover sides
B-fig. 36 on the two fastening pins and
turn it;
❒ replace the snap-fitted bulb C-fig. 36;
❒ refit bulb protection cover fitting the
two fastening pins;
❒ refit the ceiling light inserting first end
D-fig. 35 and then pressing the other
end until hearing the locking click of the
clip.
fig. 33 F0R0233m fig. 34 F0R0234m fig. 35 F0R0120m
fig. 36 F0R0121m