SUUNTO Observer - Manual (Page 21)

17
In the Daily Alarm mode (Fig. 2.7):
a) “ON” or “OFF” (the activation status of an alarm) display in the top field;
b) The alarming time displays in the middle field; and
c) The alarm (1, 2, or 3) displays in the bottom field.
Press the [ON OFF] or the [QUICK] button to toggle between the alarms 1,2, or 3 and
view the settings for each alarm. If any of the alarms is activated, a bell icon displays
over the mode bar.
2.3.1 Setting the Daily Alarm(s)
1. Press the [ON OFF] or the [QUICK] button to select alarm 1,2, or 3.
2. Press the [SELECT] button for 2 seconds. In the top field, the “ON” or “OFF” will
begin to flash.
3. Press either the [ON OFF] or the [QUICK] button to toggle between “ON” and “OFF”.
4. At the setting desired, press the [SELECT] button to move to the next settings. They
follow in order hours, minutes. The field you can change is flashing.
5. Press the [ON OFF] button to scroll the value up or the [QUICK] button to scroll down.
6. At the alarm time desired, press the [MODE] button to accept the changes and exit
the setup process. An icon of a bell will appear at the bottom left side on the middle field
to signify an alarm has been activated.
The Alarm setup is complete. To activate up to three alarms, please repeat steps 1-6.
The alarm volume is not adjustable.
CHAPTER 3 ALTIMETER MODE
The Altimeter provides you with:
•
An adjustable unit of measure either meter or feet: meter range -500 to 9000; ft
range -1,600 to 29500;
•
A resolution of 1m or 3ft;
• A display up-date on the rate of vertical movement in intervals of 1 second for 3