Machine storage, Service and repair, Disposal – RIDGID HC-300 User Manual

Page 15

HC-450/HC-300 Hole Cutting Tools

Machine Storage

WARNING

The Hole Cutting Tool must be kept in-

doors or well covered in rainy weather. Store the ma-

chine in a locked area that is out of reach of children

and people unfamiliar with hole cutting tool. This ma-

chine can cause serious injury in the hands of untrained

users.

Service and Repair

WARNING

Improper service or repair can make machine un-

safe to operate.

The “Maintenance Instructions” will take care of most

of the service needs of this machine. Any problems not

addressed by this section should only be handled by

an authorized RIDGID service technician.
Tool should be taken to a RIDGID Independent Author-

ized Service Center or returned to the factory.
For information on your nearest RIDGID Independent

Service Center or any service or repair questions:
• Contact your local RIDGID distributor.
• Visit www.RIDGID.com or www.RIDGID.eu to find

your local RIDGID contact point.

• Contact RIDGID Technical Services Department at

[email protected], or in the U.S. and

Canada call (800) 519-3456.

Disposal

Parts of the Hole Cutting Tool contain valuable materi-

als and can be recycled. There are companies that spe-

cialize in recycling that may be found locally. Dispose

of the com ponents in compliance with all applicable

regulations. Contact your local waste management au-

thority for more information.

For EC Countries: Do not dispose of electri-

cal equipment with household waste!
According to the European Guideline 2002/ -

96/ EC for Waste Electrical and Electronic

Equipment and its implemen tation into na-

tional legislation, electrical equipment that

is no longer usable must be collected separately and

disposed of in an environmentally correct manner.