RIDGID micro CA-25 - Manual (Page 8)

micro CA-25 Inspection Camera
6
Controls
Power
Status
Light
LED
Brightness
Increase
Power
Rotate Image
Figure 2 - Controls
LED
Brightness
Decrease
FCC Statement
This equipment has been tested and found
to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reason-
able protection against harmful interference
in a residential installation.
This equipment generates, uses, and can
radiate radio frequency energy and, if not
installed and used in accordance with the
instructions, may cause harmful interfer-
ence to radio communications.
However, there is no guarantee that interfer-
ence will not occur in a particular installa-
tion.
If this equipment does cause harmful in-
terference to radio or television reception,
which can be determined by turning the
equipment OFF and ON, the user is encour-
aged to try to correct the interference by
one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equip-
ment and receiver.
• Consult the dealer or an experienced radio/
TV technician for help.
Electromagnetic
Compatibility (EMC)
The term electromagnetic compatibility is ta -
ken to mean the capability of the product to
function smoothly in an environment where
elec tro magnetic radiation and electrostatic
discharges are present and without causing
electromagnet interference to other equip-
ment.
NOTICE The RIDGID micro CA-25 Inspect ion
Camera conforms to all applicable EMC stan-
dards. However, the possibility of it causing
interference in other devices cannot be pre-
cluded.
Tool Assembly
WARNING
To reduce the risk of serious injury during
use, follow these procedures for proper as-
sembly.
Changing/Installing Batteries
The micro CA-25 is supplied without batter-
ies installed. If the power status light is red,
the batteries need to be replaced. Re move
the batteries prior to long term storage to
avoid battery leakage.
1. Slide lock button toward middle to open
battery door (See Figure 3) and remove
battery compartment from the micro
CA-25 Inspection Camera (See Figure 4).
If needed, remove batteries.
Figure 3 – Battery Door
2. Install 4 new AA alkaline batteries (LR6),
observing the correct polarity as indi-
cated on the battery compartment. Only
replace in sets to help prevent battery
leakage.