SUUNTO Vyper - Manual (Page 60)

58
5.3. MAINTENANCE
The instrument should be soaked, thoroughly rinsed with fresh water, then dried
with a soft towel after each dive. Make sure that all salt crystals and sand particles
have been fl ushed out.
Check the display and the transparent battery compartment cover for possible
moisture or water. DO NOT use the dive computer, if you detect any moisture
or water inside.
CAUTION!
· Do not use compressed air to blow water off the unit.
· Do not use solvents or other cleaning fl uids that might cause damage.
· Do not test or use the dive computer in pressurized air.
5.4. WATER RESISTANCE INSPECTION
Water resistance of the unit must be checked after replacement of the battery or af-
ter other service operations. The check requires special equipment and training.
You must frequently check the transparent battery compartment cover and the
display for any sign of leaks. If you fi nd moisture inside your dive computer,
there is a leak. A leak must be corrected without delay, as moisture will seriously
damage the unit, even beyond repair. SUUNTO does not take any responsibility
for damage caused by moisture in the dive computer, if the instructions of this
manual are not carefully followed.
In case of a leak, immediately take the dive computer to an authorized SUUNTO
dealer or distributor.