Milwaukee MDE 38 Compact - Manual (Page 6)

4 English
10. Keep constant pressure throughout the entire operation to
prevent chips and burrs from falling under the cutting edges. Cutting
debris under the cutter can make cutting difficult or
impossible.
11. When the cut is complete, withdraw the cutter while the drill spindle is
still rotating.
12. Stop the drill motor by pushing in the drill on/off switch to the "OFF"
position.
13. When the drill spindle has stopped rotating, use a pliers to remove
cutting debris and chips from the cutter and spindle. Use care to avoid
damaging the cutter teeth.
14. To eject the slug from the cutter, rotate the feed handle to highest
position.
The center pin is spring loaded. Protect people and property from
ejected slug below the cutting area.
15. Firmly grip the tool and push the magnet switch to the "OFF" position.
The magnet indicator light will turn off.
Maintenance
WARNING!
To reduce the risk of personal injury and damage, never immerse
your tool, battery pack or charger in liquid or allow a liquid to flow
inside them.
Cleaning
Clean dust and debris from charger and tool vents. Keep the tool handles
clean, dry and free of oil or grease. Use only mild soap and a damp cloth
to clean your tool since certain cleaning agents and solvents are harmful
to plastics and other insulated parts.
Repairs
Use only identical MILWAUKEE replacement parts. Always take the tool
to an authorized MILWAUKEE service center for repairs and
maintenance.