Edimax Technology AR-7267WnB - Manual (Page 25)

21
in the network. Please specify the MSS range from 100 to 1452 bytes or
0 byte as the default value.
Default Route When “Default Router” is enabled, all the packets for destinations not
known by the router's routing table are sent to the default route. By
default, it is enabled.
Get IP Address Choose Static or Dynamic IP Address. If Static IP is selected, please set
the IP Address, Subnet Mask and Gateway obtained from your ISP.
Static IP Address Enter the IP Address assigned by your ISP. Only if you chose Static
above.
IP Subnet Mask Enter the Subnet Mask assigned by your ISP. Only if you chose Static
above.
Gateway Enter the Gateway assigned by your ISP. Only if you chose Static above.
NAT NAT (Network Address Translation), an Internet standard that enables a
local-area network (LAN) to use one set of IP addresses for internal
traffic and a second set of addresses for external traffic. When NAT is
enabled, the router will help to make all necessary IP address
translations for the PC connected to the router to access the Internet.
Dynamic Route Dynamic routing allows routing tables in routers to change as the
possible routes change. This router supports RIP1, RIP2-B and RIP2-M
protocols for dynamic routing. After the RIP protocol is selected, please
choose the RIP direction from “None”, “Both”, “IN Only” or “OUT Only”.
TCP MTU Option MTU (Maximum Transmission Unit) determine the maximum size of
each packet in any transmission within the network. Please specify the
MTU range from 100 to 1500 bytes or 0 byte as the default value.
IGMP Porxy Enable or disable IGMP proxy feature.
When you are done making changes, click on SAVE to save your changes.