Edimax Technology ER-1088 - Manual (Page 30)

Settings – Advanced PPTP
WAN Port Select the desired WAN port (click desired WAN on Connection Status). The
data of the selected port will then be displayed in the WAN IP Account
section.
PPTP MTU – Maximum transfer unit for PPTP. The default value is 1460
WAN IP Account • User Name – The PPTP user name (login name) assigned by your ISP.
• Password – The PPTP password associated with the User Name above.
This is assigned by your ISP, and used to login to the PPTP Server.
• Verify Password – Re-enter the PPTP password assigned by your ISP.
• Server IP Address – Enter the IP address of the PPTP Server, as
provided by your ISP.
• Static IP Address – If you have a fixed IP address, enter if here.
Otherwise, this field should be left at 0.0.0.0.
PPTP Auto Dialup • Auto Dialup (connect-on-demand) – If set to Enable, a connection will be
established whenever outgoing WAN traffic is detected. If not enabled,
you must establish a connection manually.
• Disconnect after Idle – This determines when an idle connection will be
terminated. Enter the required time period. (-1: Always on)
• Echo Time – This determines how often an Echo request is sent to the
PPTP server. The Echo request is used to determine if the connection is
still alive. Normally, there is no need to change the default value.
• Echo Retry – The number of times the Echo request will be sent, if there
is no response to the first request. Normally, there is no need to change
the default value.
Connection
Status This displays the current PPTP connection status.
Page 26