3M Multimedia Projector X62w - Manual (Page 51)

51
3. How to use Projector software – Basics -
2) Start Web Remote Control (refer to 2.6 Utilize Web Remote Control), and click
“LIVE MODE” button on Web Remote Control to change projector mode to
“MIU Live Viewer”. After changing, screen of the output monitor connected with
projector turn all blue.
3) Perform following operations on “MIU Live Viewer”
(1) Click “Find” button to search communication available projector. If any
projector is not found at “Enable Device” tab, try search again after referring
section 2.2.
3.1 How to use “MIU Live Viewer” (Continued)
Display communication possible
projector like this if available as a
result of search.
Fig. 3.1.4.b. Projector research result display (1)
(2) When communication available projector is found at 1), click the found
projector to select
Click the projector line to connect.
IP address appears in the upper
column.
Fig. 3.1.4.c Projector research result display (2)