Setting up, Fastening the lens cap – 3M X75 User Manual

Page 6

Setting up

WARNING ►Place the projector in a stable position horizontally. A fall or

a turnover could cause an injury and/or damage to the projector. Then using

damaged projector could result in a ﬁ re and/or an electric shock.

• Don’t place the projector on an unstable, slant or vibrant surface such as a

wobbly or inclined stand.

• Do not place the projector in the side/front/rear-up position, except care of the air ﬁ lter.

• For the projector installed bottom-up, use the accessory ﬁ lter cover for bottom-

up use. And in the case of a ceiling installation or the like, contact your dealer

before installation.

►Place the projection in a cool place, and pay attention enough to ventilation.

The high temperature of the projector could cause a ﬁ re, a burn and/or

malfunction to the projector.

• Don’t stop up, block and cover the projector's vents.

• Keep a space of 30 cm or more between the sides and other objects such as walls.

• Don’t place the projector on a metallic thing or anything weak in heat.

• Don’t place the projector on a carpet, cushion or bedding.

• Don’t place the projector in direct sunlight or near a hot object such as heater.

• Put nothing about lens and vents of the projector. Put nothing on the projector.

• Put nothing that is sucked or sticks to the bottom of projector. This projector

has some intake vents also on the bottom.

►Do not place the projector on the place that gets wet. Damping the projector

or inserting liquid in the projector could cause a ﬁ re, an electric shock and/or

malfunction to the projector.

• Don’t place the projector in a bathroom or the outdoors.

• Put nothing containing the liquid near the projector.

CAUTION ►Avoid a smoky, humid or dusty place. Placing the projector in

such place could cause a ﬁ re, an electric shock and/or malfunction to the projector.
• Don’t place the projector near a humidiﬁ er, a smoking space or a kitchen.

• Put nothing containing the liquid near the projector.

►Adjist the direction of the projector to keep light from directly hitting the

projector's remote sensor.

Fastening the lens cap

To avoid losing, please fasten the lens cap to the projector using the strap.

Fix the strap to the strap ring of lens cap.

Put the strap into the groove on rivet.

Push the rivet into the strap hole.

Strap ring

Strap

Strap hole

Strap hole Bottom side