3M X75 - Manual (Page 38)

38
Multifunctional settings
OPTION Menu
Item Description
ONE TOUCH
Using the buttons ▲/▼ turns on/off the automatic keystone
correction function.
TURN ON  TURN OFF
You can automatically correct vertical keystone distortion
corresponding to the angle (forward/backward tilt) at which the unit
is set up. This function works with ONE TOUCH operation.
• If the projection screen is inclined, or if the projector is angled
downwards, it may not be possible to make the correct adjustment
when V: INVERT or H&V: INVERT is selected under the MIRROR
item of the SETUP menu.
• When the zoom adjustment is set to the TELE side, automatic
correction may be excessive. The automatic correction function
should be used with zoom set to WIDE whenever possible.
AUTO SEARCH
Using the buttons ▲/▼ turns on/off the automatic signal search
function.
TURN ON  TURN OFF
This function works with INPUT, RGB, and VIDEO buttons.
When the TURN ON is selected, detecting no signal automatically
cycles through input ports in order of following. The search is
started from the current port. Then when an input is found, the
projector will stop searching and display the image.
RGB IN1  RGB IN2  DVI-D  COMPONENT VIDEO  S-VIDEO  VIDEO
AUTO OFF
Using the buttons ▲/▼ adjusts the time to count down to
automatically turn the projector off.
Long (max. 99 minutes)  Short (min. 0 minute = DISABLE)
AUTO OFF
ENABLE
1
AUTO OFF
DISABLE
0
When the time is set to 0, the projector is not turned off automatically.
When the time is set to 1 to 99, and when the passed time with
a no-signal or an unsuitable signal reaches at the set time, the
projector lamp will go off and the power indicator begins blinking.
Please refer to the section “Turning off the power” (  16).
With the OPTION menu, items shown in the table below
can be performed.
Select an item using the cursor buttons ▲/▼ on the
projector or remote control, and press the cursor button ►
on the projector or remote control, or the ENTER button on
the remote control to progress, except for the items LAMP
TIME and FILTER TIME. Then perform it referring to the
following table.
MENU [RGB]
VIDEO Qlty.
SETUP
PICTURE
INPUT
OPTION
EASY MENU
SCREEN
:SELECT
AUTO OFF 0
LAMP TIME 0
FILTER TIME 0
ONETOUCH
AUTO SEARCH TURN OFF
IMAGE
NETWORK
SERVICE