Yamaha RX-V470 - Manual (Page 24)

24
Battery installation
1
Press the lid's locking tab down and, at the same time,
pull out the battery compartment lid in the direction of
the arrow.
Remote control transmitter operation
range
Remote control sensor
Within approximately
7 m (23 feet)
Notes
÷ There should be no large obstacles between the remote
control transmitter and the main unit.
÷ If the remote control sensor is directly illuminated by
strong lighting (especially an inverter type of fluorescent
lamp etc.), it might cause the remote control transmitter
not to work correctly. In this case, reposition the main unit
to avoid direct lighting.
NOTES ABOUT THE REMOTE CONTROL TRANSMITTER
2
Install the batteries (size AA, R6, UM-3) with correct
polarities. Follow the diagram in the compartment.
+
–
+
–
3
Position the bottom portion of the compartment lid in
place, and push the top portion of the lid in until it clicks
into place.
Battery replacement
If you find that the remote control transmitter must be used
closer to the main unit, the batteries are weak. Replace
both batteries with new ones.
Notes
÷ Use only AA, R6, UM-3 batteries for replacement.
÷ Be sure the polarities are correct. (See the illustration
inside the battery compartment.)
÷ Remove the batteries if the remote control transmitter will
not be used for an extended period of time.
÷ If batteries leak, dispose of them immediately. Avoid
touching the leaked material or letting it come in contact
with clothing, etc. Clean the battery compartment
thoroughly before installing new batteries.
30° 30°