ZyXEL Communications PRESTIGE 128 - Manual (Page 63)

50 Remote Node Configuration
Remote Node Configuration
A Remote Node represents both a remote gateway and the internet
behind it, across an ISDN connection. A Remote Node is required
for placing calls to or answering calls from a remote network. Note
that when you use Menu 4 to configure the Internet, the Prestige
will automatically add a Remote Node for you. Once a Remote
Node is configured properly, traffic to the remote LAN will trigger
the Prestige to make a call automatically (i.e., Dial On Demand).
Similarly, calls from the remote LAN will be answered
automatically and security will be checked.
In this chapter, we will discuss the parameters that are protocol
independent. The protocol dependent configuration will be covered
in subsequent chapters. For TCP/IP, see Chapter 7. For IPX, see
Chapter 8. For bridging, see Chapter 9.
From the Main Menu, enter 11 to go to Menu 11 - Remote Node
Setup. When in menu 11, enter the number of the Remote Nodes
(1 to 4) that you wish to configure as shown below: