ZyXEL Communications PRESTIGE 128 - Manual (Page 55)

42 Configuring for Internet Access
Once you have determined the IP address range for your local
network, you may want to use DHCP (Dynamic Host
Configuration Protocol) to assign addresses to individual hosts on
the network, as an alternative to manually configuring each host’s
IP settings. See the TCP/IP Ethernet Setup and DHCP section on
page 36 for more information about DHCP.
Internet Access Configuration
The following steps describe the set-up procedure to configure
your Prestige for Internet access. The information you will need to
provide will be indicated in bold type.
Figure 4-2 Menu 4 - Internet Access Setup
1. From the Main Menu, enter 4 to go to Menu 4 - Internet
Access Setup as seen above.
2. ISP’s Name - Enter the name of your Internet Service
Provider, e.g., myisp. This information is for identification
purposes only.
3. ISP IP Addr - Enter the IP Address of the remote gateway at
the ISP’s site. If you do not have this data, just leave it blank.