Additional information, Troubleshooting, Troubleshooting” on – Yamaha RX-V461 User Manual
Page 69: Troubleshooting” on pag, General
Troubleshooting
65
En
English
AD
DITIONAL
INFO
RM
A
T
ION
Refer to the table below when this unit does not function properly. If the problem you are experiencing is not listed below
or if the instruction below does not help, turn off this unit, disconnect the power cable, and contact the nearest authorized
Yamaha dealer or service center.
■ General
Troubleshooting
Problem
Cause
Remedy
See
page
This unit fails to turn
on or enters the
standby mode soon
after the power is
turned on.
The power cable is not connected or the
plug is not completely inserted.
Connect the power cable firmly.
—
The speaker impedance setting is
incorrect.
Set the speaker impedance to match your speakers.
The protection circuitry has been
activated.
Make sure that all speaker wire connections on this
unit and on all speakers are secure and that the wire
for each connection does not touch anything other
than its respective connection.
This unit has been exposed to a strong
external electric shock (such as lightning
or strong static electricity).
Set this unit to the standby mode, disconnect the
power cable, plug it back in after 30 seconds and then
use it normally.
—
No sound
Incorrect input or output cable
connections.
Connect the cables properly. If the problem persists,
the cables may be defective.
No appropriate Audio input jack select has
been set.
Set an appropriate Audio input jack select.
No appropriate input source has been
selected.
Select an appropriate input source with DINPUT
l / h on the front panel (or the input selector
buttons on the remote control).
Speaker connections are not secure.
Secure the connections.
The front speakers to be used have not
been selected properly.
Select the front speakers with 9SPEAKERS on the
front panel.
The volume is turned down.
Turn up the volume.
—
The sound is muted.
Press LMUTE or JVOLUME +/– on the remote
control to resume audio output and then adjust the
volume.
Signals this unit cannot reproduce are
being input from a source component,
such as a CD-ROM.
Play a source whose signals can be reproduced by this
unit.
—