Yamaha RX-V461 - Manual (Page 44)

40
En
FM/AM tuning
You can tune into any desired station simply by selecting
the preset station group and number under which it was
stored.
y
When performing this operation with the remote control, set the
operation mode selector (K) to SOURCE and then press
ATUNER to select “TUNER” as the input source.
1
Press 4
A/B/C/D/E (or DA-E/CAT. l / h)
repeatedly to select the desired preset
station group (A to E).
The preset station group letter appears in the front
panel display and changes each time you press the
button.
2
Press 5
PRESET/TUNING/CH l / h (or
D PRESET/CH k / n) to select the desired
preset station number (1 to 8).
The preset station group and number appear in the
front panel display along with the station band and
frequency.
y
You can select the desired preset station number (1 to 8) directly
by pressing the numeric buttons on the remote control.
You can exchange the assignments of two preset stations
with each other. The example below describes the
procedure to exchange preset station “E1” with “A5”.
1
Select preset station “E1” using 4
A/B/C/D/E
and 5
PRESET/TUNING/CH l / h.
See “Selecting preset stations” on this page.
2
Press and hold 2
PRESET/TUNING for
more than 3 seconds.
“E1” and the MEMORY indicator flash in the front
panel display.
3
Select preset station “A5” using 4
A/B/C/D/
E and 5PRESET/TUNING/CH l / h.
“A5” and the MEMORY indicator flash in the front
panel display.
See “Selecting preset stations” on this page.
4
Press 2
PRESET/TUNING again.
“EDIT E1–A5” appears in the front panel display and
the assignments of the two preset stations are
exchanged.
Selecting preset stations
: E1 FM 87.5 MHz
Exchanging preset station
MEMORY
: E1 FM 87.5 MHz
Flashes
Flashes
MEMORY
: A5 FM 90.6 MHz
Flashes
Flashes