Xerox 701P46985 - Manual (Page 13)

FREEFLOW PRINT SERVER 6.0.xx
XEROX FREEFLOW PRINT SERVER 7
GETTING READY FOR THE PRINT SERVER INSTALLATION
W-1 data element definitions
Primary Network Interface:
Product Controller/Server Value
iGen3 PDSI Config 4 bge0
DocuColor (2XX, 5000,
7000/8000) PDSi Config 2b,
2c, 2d bge0
DocuTech 61XX
DocuPrint 1XX EPS
PDSi Config 2a bge0
DocuTech 61XX
DocuPrint 1XX EPS
SUN W1100z Determined
automatically
DocuTech 128/155/180
HLC PDSi Config 2a bge1
DocuTech 128/155/180
HLC SUN W1100z ce1
Xerox 41XX/45XX EPS,
XXP SUN Ultra 20 Determined
automatically
Xerox Continuous Feed PDSi Config 4 bge1
Nuvera X86 Determined
automatically
DHCP: Dynamic Host Configuration Protocol. This is a TCP/IP
addressing method. If selected, the system should automatically
contact the DHCP server to obtain the IP address, subnet mask,
and default gateway address. This information can also be
manually entered into the FreeFlow Print Server Network
Configuration screens.
DHCP is the default for DocuColor 2XX. iGen3 may not use
DHCP.
Hostname: This is the name the print server will be known as
by users from other host machines on the TCP/IP network. This
name is an alias mapped to the IP address that is assigned to
the print server/host machine. The Hostname must start with an
alphabetic character, and cannot start with a number, space, or
any other non-alphabetic character.
IP Address: The lP or Internet Address is a unique 4 byte, 32
bit numeric value that is assigned to each local host and
workstation on a TCP/IP network. An IP address consists of four
fields, each separated by a decimal point. For example:
13.254.166.111.
NOTE: The TCP/IP Internet spans the entire world. The Internet
central committee assigns a set of unique network addresses to