Zenoah SGCZ2610DL - Manual (Page 15)

GB-15
G
B
SGCZ2610DL/SGCZ2610DW
Spark arrester
WARNING
Make sure that the engine has stopped and is cool
before performing any service to the machine. Con-
tact with moving cutting head or hot muffler may re-
sult in a personal injury.
AIR FILTER
• The air filter, if clogged, will reduce the engine perfor-
mance. Check and clean the filter element in warm,
soapy water as required. Dry completely before in-
stalling. If the element is broken or shrunk, replace
with a new one.
FUEL FILTER
• When the engine runs short of fuel supply, check the
fuel cap and the fuel filter for blockage.
SPARK PLUG
• Starting failure and miss-firing are often caused by a
fouled spark plug. Clean the spark plug and check
that the plug gap is in the correct range. For a re-
placement plug, use the correct type specified by
ZENOAH.
• REPLACEMENT PLUG IS A NGK CMR7H.
9. Maintenance
Fuel filter
Air Filter
0.6 to 0.7 mm
IMPORTANT
• Note that using any spark plug other than those des-
ignated may result in the engine failing to operate
properly or in the engine becoming overheated and
damaged.
• To install the spark plug, first turn the plug until it is
finger tight, then tighten it a quarter turn more with a
socket wrench.
MUFFLER
WARNING
• Inspect periodically, the muffler for loose fasten-
ers, any damage or corrosion. If any sign of ex-
haust leakage is found, stop using the machine
and have it repaired immediately in the repair spe-
cialty store.
• Note that failing to do so may result in the engine
catching on fire.
SPARK ARRESTER
• The muffler is equipped with a spark arrester to pre-
vent red hot carbon from flying out of the exhaust out-
let. Periodically inspect and clean as necessary with
a wire brush in the repair specialty store.
ANGLE TRANSMISSION
• Periodically refill the case with grease (every 25 hours).
• Use only lithium based greases.
TIGHTENING TORQUE:
9.8 ~ 11.8 N.m.
(1 ~ 1.2 kgm)
Air purge
Bolt
Screw
Plane washer
Grease:
approx. 10cc
Grease: approx. 5cc