Maintenance – Zenoah SGCZ2610DL User Manual

Page 14

GB-14

SGCZ2610DL/SGCZ2610DW

9. Maintenance

BLADE
Wipe off dust and dirt attached to the blades, and oil
them after every use.

To sharpen blade:
1. When the cutting edges have become dull, sharpen

them by using a small disk grinder. (a)

2. When sharpening, offset the teeth of upper and lower

blades by 3mm. (b) To offset, insert the hexagon
wrench into the socket on the top of the angle trans-
mission and rotate it.

• Replace with new blades when the tooth width be-

came less than 8mm at the tip. (c)

• As the extent of wear differs by each tooth depend-

ing on use conditions, rotate the blade position at in-
tervals.

To remove blades:
1. Turn over the machine and remove the bottom cover

(1) by removing the 4 screws.

2. Loosen 4 screws and remove the lower blade (2)
3. Loosen 4 screws and remove the upper blade (3).

To install blades:
The upper and lower blades are interchangeable. When
fastening the blade mounting screws, torque them uni-
formly.

• Before cleaning, inspecting, or repairing the unit, make sure that the engine has stopped and is cool.
• Use protective gloves whenever inspecting, removing, sharpening, and installing the blades.

Every Every Every

100

System/components

Procedure

Before

hours hours hours Note

use

after

fuel leaks, fuel spillage

wipe out

✔

fuel tank, air filter, fuel filter

inspect/clean

✔

replace, if necessary

see adjusting

replace carburetor

idle speed adjuster

✔

idling speed

if necessary

clean and readjust

GAP: .025 in (0.6 ~ 0.7 mm)

spark plug

✔

plug gap

replace, if necessary

intake air cooling vent

clean

✔

throttle trigger, stop switch

check operation

✔

replace if

cutting parts

✔

something’s wrong

angle transmission

grease

✔

screws/nuts/bolts

tighten/replace

✔

except adjusting screws

cutting attachment guard

make sure to attach

✔

ENGINE

SHAFT

MAINTENANCE CHART