Operation – Zenoah SGCZ2610DL User Manual

Page 11

GB-11

SGCZ2610DL/SGCZ2610DW

idle speed adjuster

(1)

(3)

(2)

(1) Cable adjuster
(2) 0.04in (1~2mm)
(3) Screw

stop

start

(1)

STARTING ENGINE

WARNING

The cutting head will start rotating upon the engine
starts.

1. Rest the unit on a flat, firm place. Keep the cutting

head off the ground and clear of surrounding objects
as it will start rotating upon starting of the engine.

2. Push the primer pump several times until overflown

fuel flows out in the clear tube.

3. Move the choke lever to the closed position.

[SGCZ2610DL]

[SGCZ2610DW]

4. Set the stop switch to the “-” position. Set the throttle

trigger to the start position (1 → 2 → 3).
Place the unit on a flat, firm place.
Keep the cutting head clear of everything around it.

5. Place the unit on a flat, firm place. Keep the cutting

head clear of everything around it.

6. While holding the unit firmly, pull out the starter rope

quickly.

IMPORTANT

Avoid pulling the rope to its end or returning it by releas-
ing the knob. Such actions can cause starter failures.

7. Move the choke lever downward to open the choke.

And restart the engine.

8. Allow the engine to warm up for a several minutes

before starting operation.

NOTE

1. When restarting the engine immediately after stop-

ping it, leave the choke open.

2. Overchoking can make the engine hard to start due

to excess fuel. When the engine failed to start after
several attempts, open the choke and repeat pulling
the rope, or remove the spark plug and dry it.

STOPPING ENGINE
1. Release the throttle trigger and run the engine for a

half minute.

2. Shift the stop switch to the “Stop” position.

IMPORTANT

Except for an emergency, avoid stopping the engine
while pulling the throttle trigger.

IMPORTANT

When it doesn’t stop at the stop switch,
move the choke lever to the closed
position.

ADJUSTING THROTTLE CABLE
• The normal play is 1 or 2 mm when measured at the

carburetor side end. Readjust with the cable adjuster
as required and tighten the screw up.

ADJUSTING IDLING SPEED
1. When the engine tends stop frequently at idling mode,

turn the adjusting screw clockwise.

2. When the cutting head keeps rotating after releasing

the throttle trigger, turn the adjusting screw counter-
clockwise.

NOTE

Warm up the engine before adjusting the idling speed.

8. Operation

(1)

Stop switch

choke lever

open