Yamaha GX-90VCD - Manual (Page 23)

E-13
English
Connecting external components
(See figure 9 on page 9 9 .)
This system can be connected with external audio and video
components. Make connections between this system and
other components using RCA pin plug connector cables
correctly, that is to say L (left) to L and R (right) to R. Also,
refer to the owner’s manual for each component to be
connected to this system.
Connecting the AC supply lead
(See figure @ on page 1 10 0 .)
•
After completing all connections, plug the AC supply lead
into a convenient AC outlet.
•
Unplug the AC supply lead from the AC outlet if the unit is
not to be used for a long period of time.
CONNECTIONS
The Video-CD player on this system is designed for use with
the NTSC and PAL television formats. Set this switch to the
position for the format your monitor TV employs.
PAL: Outputs signals in the PAL format no matter which
format (PAL or NTSC) the currently playing disc
employs.
Set to this position if your monitor TV employs the
PAL format.
AUTO: Outputs signals in the same format as the currently
playing disc employs.
Set to this position if your monitor TV can be
switched in between the PAL and NTSC formats
automatically.
NTSC: Outputs signals in the NTSC format no matter which
format (PAL or NTSC) the currently playing disc
employs.
Set to this position if your monitor TV employs the
NTSC format.
Note
Make sure to play back a disc which employs the same
format that your monitor TV employs, otherwise a picture will
not be played back normally.
SETTING THE VIDEO OUTPUT FORMAT SELECTOR (TV MODE) SWITCH
STANDBY mode
While the power is on, pressing the POWER switch (or the
POWER switch on the remote control transmitter) switches
the system to the STANDBY mode. (In this mode, the
display shows only the time.) In this mode, main voltage is
still present inside the system. If you want to switch off the
system completely, disconnect the AC power plug from the
AC outlet.
TURNING THE POWER ON/OFF TO THIS SYSTEM
(See figure A on page 1 10 0 .)
If the AC supply lead is connected to the AC outlet, this
system can be turned ON and OFF (STANDBY mode) by
pressing the POWER switch on the front panel of the main
unit or the POWER switch on the remote control transmitter.
Automatic power-off function
The power of this system will be automatically turned off if
there is no operation on the control parts of this system, no
illumination on the graphic equalizer level indicators and no
playback of CD or tape for about 30 minutes.
*
This function is not available unless time setting is made
on the built-in clock.
ANTENNA
FRONT SPEAKERS
DO NOT CONNECT THIS UNIT TO SPEAKERS OTHER
THAN NX-C70 (CENTER) OR NX-E70 (REAR).
R L
R L
R L
SINCE THIS UNIT HAS AN ACTIVE SERVO CIRCUIT BUILT–IN. DO NOT CONNECT IT TO SPEAKERS OTHER THAN NX–GX70.
75 Ω UNBAL.
REAR CENTER REAR
FM GND AM
SPEAKERS CENTER/REAR
OUT
IN
VCR
LD/TV
OUT
MD/AUX
IN
AUDIO SIGNAL
OUT
SUBWOOFER VIDEO SIGNAL
MONITOR OUT
CENTER MODE NORMAL PHANTOM TV MODE PAL
NTSC AUTO
TV MODE
PAL
NTSC
AUTO