Yamaha Clavinova CLP-98 - Manual (Page 7)

CVP-98/96/600
○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
Troubleshooting
Problem
The power of the Clavinova does
not turn on.
A click or pop sound is produced
when turning on/off the power.
The LCD display is too bright or
too dark to read.
The pop-up display does not open.
The keyboard sound volume is low
compared to that of the Auto Ac-
companiment or disk playback.
The sound of the Auto Accompani-
ment or disk playback is low com-
pared to that of the keyboard.
The entire sound is low or no sound
comes out.
The damper pedal has no effect, or
the sound continuously sustains
even when the damper pedal is not
pressed.
Auto Accompaniment or disk play-
back does not start.
When the keyboard is played, not
all of the notes sound.
Auto Accompaniment does not play
back.
Solution
Securely insert one of the cable
plugs into the instrument itself, and
the other plug into a proper AC
outlet.
This is normal, and is no cause for
concern.
Adjust the contrast of the display by
using the [CONTRAST] control. (See
page 15 in the Owner’s Manual.)
Press the [DISPLAY HOLD] but-
ton so that the lamp goes out. (See
page 15 in the Owner’s Manual.)
Raise the volume of the keyboard per-
formance in the Mixer display. (See
page 94 in the Owner’s Manual.)
Raise the [ACMP/SONG VOL-
UME] level.
Raise the [MASTER VOLUME].
Unplug the headphones.
Set Local Control to on. (See page
144 in the Owner’s Manual.)
Securely insert the pedal cord plug
into the proper jack. (See page 40
in this manual for the CVP-600 and
page 48 for the CVP-98/96.)
Set MIDI Sync to “INT.”. (See
page 144 in the Owner’s Manual.)
The tone generation system is
configured such that later notes
have priority, occasionally resulting
in previous notes being cut off. See
the “Specifications” section on page
37 in this Manual for information
on the simultaneous polyphonic
capacity.
Press the [ACMP ON] button to
turn on Auto Accompaniment.
Cause
The power cable plugs are not in-
serted either in the Clavinova or a
proper AC outlet.
Electrical current is flowing into the
instrument.
The brightness may be changed by
the surrounding temperature.
The [DISPLAY HOLD] lamp is lit.
The independent volume level of the
keyboard performance sound is too
low.
The [ACMP/SONG VOLUME] is
low.
The [MASTER VOLUME] is low.
Headphones are connected.
Local Control is set to off.
The pedal cord plug is not connected.
MIDI Sync is set to “EXT.”.
Notes have been played beyond the
total simultaneous polyphonic capac-
ity (maximum number of notes).
Auto Accompaniment is not turned
on.
6