Yamaha GX-700 - Manual (Page 48)

E-40
This system will be set to the standby mode automatically
when the selected sleep time passes.
1
Play the desired sound source.
2
Press SLEEP repeatedly until the desired sleep time
appears on the display. The display will change as
described below.
* The normal display mode will resume about 4 seconds
after the selection is made.
* “SLEEP” will light up on the display.
2h00m 1h30m 1h00m 0h30m
OFF SLEEP
(Sleep timer is off.)
Sleep timer operation
Using the built-in timer
DISC 1 DISC 2 DISC 3
DOWN UP
VOLUME
STANDBY/ON
DIRECTION
PROGRAM B.BOOST MUSIC INPUT INPUT
MIN
PTY SELECT PRESET/ TUNING/ BAND A/B/C/D/E
DISC CHANGE OPEN / CLOSE
AUTO/MANUAL
TIMER
MEMORY
TIME ADJ
REC/PAUSE DOLBY NR
HOUR
FREQ PS/PTY/RT/CT
RANDOM
MODE– PTY SEEK– START
REPEAT TIME
DISPLAY MODE
1
Follow steps 2–3 of “Basic recording” on page 28.
2
Tune in to the station you want to record.
3
Follow step 1 of “Timer play” on page 39.
* In step 2 , select “TUNER”, and then press REC/
PAUSE. (“REC > TAPE” and the frequency will flash
alternately on the display.)
* In step 3 , set the time when you want to begin
recording.
* In step 4 , set the time when you want to finish
recording.
4
Press TIMER.
This system will be set to the standby mode.
* The STANDBY and TIMER indicators light up.
To cancel the setting of timer recording
Press DISPLAY once or more so that “REC > TAPE” flashes
on the display. While “REC > TAPE” is flashing, press REC/
PAUSE.
Note
When the timer recording is finished, the timer setting is
automatically canceled.
3
DISPLAY
Timer recording
PROGRAM
BASS
BOOST MUSIC
CENTER/
REAR/DELAY TEST
LEVEL
VOLUME POWER SLEEP
/I
REC/PAUSE
DIRECTION TAPE
1
1
2
2
3
3
4
4
5
5
6
6
7
7
8
8
9 0
TIME PROG R. TIME
C
EDIT
D
PRESET
+ I0
E
MODE REPEAT RANDOM TUNER
DISC SKIP
A B
TUNER CD
INPUT
3
3
4
3
STANDBY/ON
POWER
SLEEP