Yamaha GX-700 - Manual (Page 32)

E-24
DISC 1 DISC 2 DISC 3
DOWN UP
VOLUME
STANDBY/ON
DIRECTION
PROGRAM B.BOOST MUSIC INPUT INPUT
MIN
PTY SELECT PRESET/ TUNING/ BAND A/B/C/D/E
DISC CHANGE OPEN / CLOSE
TREBLE
AUTO/MANUAL
TIMER
MEMORY
TIME ADJ
REC/PAUSE DOLBY NR
HOUR
FREQ PS/PTY/RT/CT RANDOM MODE– PTY SEEK– START
REPEAT TIME
DISPLAY MODE
1
2
3
Tuning operation
Ⅵ
Other functions which make use of RDS
data service
The tuner has the following functions which make use of RDS
data service. These are originally in operation [ON].
However, you can cancel these functions [OFF], if so desired.
1
ON (OFF) CT > CLOCK
The tuner corrects the time of the built-in clock
automatically by synchronizing it with the CT data on the
RDS station being received.
* If you receive an RDS station of some other country, the
built-in clock is synchronized with the time setting of the
country.
* If the built-in clock is not yet set for the current time or
reset due to a power failure etc., it will be set for the time
of the CT data automatically, whether this setting is ON
or OFF.
2
ON (OFF) LOCAL > CT
If the RDS station being received employs the local time
(summer time etc.) data service, its time is displayed in the
CT mode.
* If the setting of function
1
is “ON”, the built-in clock is
synchronized with the local time data.
3
ON (OFF) A. M. – RDS (AUTO MEMORY
>
RDS)
Only RDS stations are searched instead of all FM stations
by the automatic preset tuning operation when the setting
is ON. (Refer to page 20 for the operating procedure.)
If you switch this function OFF, not only RDS stations but
also other FM stations are programmed along with AM
stations by the automatic preset tuning operation.
To switch these functions on and off
1
Select the FM band by pressing the PRESET/TUNING/
BAND, confirming it on the display.
2
Press DISPLAY to display the current time.
3
Press FREQ PS/PTY/RT/CT.
The title of function
1
“ON CT > CLOCK ” is displayed.
4
Select the title of function whose setting you want to switch
by pressing PTY SEEK MODE once or more.
5
Switch the function ON or OFF by pressing PTY SEEK
START, confirming it on the display.
6
Press FREQ PS/PTY/RT/CT again to restore the frequency
display mode.
* If the station has PS data, after the frequency display
mode returns, it turns into the PS mode.
Notes
●
Once the setting is changed, it will be stored until it is
changed again by the above operation.
● During the operation, if there is no operation for about 20
seconds, this mode is canceled and turns into the
frequency display. If the station has PS data, after that, it
turns into the PS mode.
1
2
3, 6
5
4