Yamaha CVP-200 - Manual (Page 5)

CVP-98/96/600
○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
Messages
● Custom Style Related Messages
This message appears for a few seconds when the Custom Style mode is engaged. (See
page 68 in the Owner’s Manual.)
This confirmation prompt appears when you attempt to change the beat parameter in the
Custom Style mode. (See page 70 in the Owner’s Manual.)
This confirmation prompt appears when you attempt to change the number of measures
in the Custom Style mode. (See page 70 in the Owner’s Manual.)
This confirmation prompt appears when you attempt to perform operations which can only
be done after deleting the part of the original style in the Custom Style mode. (See page
71 in the Owner’s Manual.)
This confirmation prompt appears when you attempt a store operation in the Custom
Style mode. (See page 74 in the Owner’s Manual.)
This also appears when you attempt to change styles before storing. (See page 79 in
the Owner’s Manual.)
This confirmation prompt appears when you attempt to exit from the Custom Style mode
before storing data. (See page 79 in the Owner’s Manual.)
➾ Select YES to store. Press NO to exit without storing data. Press CANCEL to return to
the previous display without storing data. (See page 79 in the Owner’s Manual.)
This message appears when the Recall Section operation in the Custom Style mode
cannot be performed, due to changes in the time signature (beat). (See page 74 in the
Owner’s Manual.)
If the data has not been stored to memory before saving to disk in the Custom Style
mode, this message prompts you to store the data before proceeding. (See page 76 in
the Owner’s Manual.)
This message appears if there is not enough internal memory space left when storing
data in the Custom Style mode. (See page 78 in the Owner’s Manual.)
This message appears when DELETE is selected from the display shown above.
➾ Select the style to be deleted and press the OK button. Press CANCEL if you do
not want to delete the style.
This message appears when memory capacity has become full during recording in the
Custom Style mode (page 78 in the Owner’s Manual). This also appears when memory
has become full during recording of a song to internal RAM. In this case, recording will
stop and data recorded up to that point will be saved automatically.
This message prompts you to insert the source disk when copying songs to a second
disk. (See page 137 in the Owner’s Manual.)
This appears when the same song number is selected for both source and destination in
the song copy operation.
➾ Change the destination song number.
4