Znyx Networks bh5700 - Manual (Page 264)

bridge will not send or receive BPDUs, and will thus not
participate in the Spanning Tree Protocol. If your bridge
isn't the only bridge on the LAN, or if there are loops in the
LAN's topology, DO NOT turn this option off. Turning this
option off may impair network traffic, so be careful.
setbridgeprio
sets the bridge's priority to . The priority value
is an unsigned 16-bit quantity (a number between 0 and 65535),
and has no dimension. Lower priority values are better. The
bridge with the lowest priority will be elected Root Bridge.
setfd
sets the bridge's bridge forward delay to seconds.
sethello
sets the bridge's bridge hello time to seconds.
setmaxage
sets the bridge's maximum message age to seconds.
setpathcost
sets the port cost of the port (zre#) to . This is a
dimensionless metric. The path cost is set to 100 for all
OpenArchitect switch ports by default. For the OpenArchitect
switch a port is zre1, zre2, … IEEE 802.d recommends the
following:
setportprio
sets the port's priority to . The priority value (a
number between 0 and 255), and has no dimension. This metric
is used in the designated port and root port selection
algorithms. For the OpenArchitect switch a port is zre1, zre2,
…
NOTES
brctl(8) replaces the older brcfg tool.
Ethernet Switch Blade User's Guide release 3.2.2j page 264
Link
Speed Recommended
Value Recommended
Range
10 Mb/s 100 50-600
100 Mb/s 19 10-60
1 Gb/s 4 3-10