Yamaha CVP-109 EN - Manual (Page 55)

55
CVP-109/107/105/700
If the lamp does not light, neither effect system has been assigned to
the part in question. Check the PART function settings (page 57).
If the lamp lights but the sound of the voice does not change, the effect
depth may have been set to 0. Check the effect depth settings (page 57).
• The setting of the [EFFECT] button
has no effect on song mode or Auto
Accompaniment playback, or on audio
signals input via a microphone (CVP-
109/107/700).
• When an effect system is used by a
song, it is automatically turned off for
the keyboard part(s) when that song is
selected for playback. If you press
[EFFECT] to apply an effect to the
keyboard part(s) after selecting the
song, the effect will not be applied to
the song.
To turn an effect off, select the part that uses that effect in the main
display and press [EFFECT] again.
➔ The lamp turns off, and the effect icon and effect type are no
longer displayed.
Because the basic setting of the [EFFECT] button depends on the
voice, the effect(s) may turn on or off automatically when you select a
different voice.
You can change the effect type, depth and affected part using the set-
tings on the EFFECT pages.
■ Displaying the Effect Settings
.............................................................
Press [DIRECT ACCESS], then [EFFECT] to display the EFFECT
display pages.
Changing the Effect Settings
Use the PAGE [<] and [>] buttons to switch between the EFFECT 1
page and the EFFECT 2 page. If you press the [ < ] button while the
EFFECT 1 page is showing, the CHO-
RUS page will be displayed. Refer to the
first two sections of this chapter for de-
tails on reverb and chorus settings.
○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
Voice Effects (CVP-109/107/700)
➔ The LCD displays either the EFFECT 1 page or the EFFECT 2 page
(whichever was selected most recently).
EXIT DIRECT ACCESS ➾ DUAL SPLIT REVERB CHORUS EFFECT
53
CVP-107/700