Zebra Technologies 2844 - Manual (Page 4)

SHOCK HAZARD WARNING:
The printer and power supply should never be operated in a
location where either one can get wet. Personal injury could
result.
MEDIA AND RIBBON WARNING:
Always use high quality, approved labels, tags and ribbons. If
adhesive backed labels are used that DO NOT lay flat on the
backing liner, the exposed edges may stick to the label guides
and rollers inside the printer, causing the label to peel off from
the liner and jam the printer. Permanent damage to the print
head may result if a non-approved ribbon is used as it may be
wound incorrectly for the printer or contain chemicals
corrosive to the print head. Approved supplies can be ordered
from your dealer.
RELOADING HINT:
If labels or ribbon run out while printing, DO NOT turn the
power switch OFF (0) while reloading or data loss may result.
The printer automatically restarts after you load a new label or
ribbon roll.
STATIC DISCHARGE:
The discharge of electrostatic energy that accumulates on the
surface of the human body or other surfaces can damage or
destroy the print head or electronic components used in this
device. DO NOT TOUCH the print head or the electronic
components under the top cover.
THERMAL PRINTING:
The print head becomes hot while printing. To protect from
damaging the print head and risk of personal injury, avoid
touching the print head. Use only the cleaning pen to perform
maintenance.
iv
980348-001 Rev. A