Xerox DocuColor 7002 - Manual (Page 6)

www.xerox.com/Section508 6 of 10
Last Revision: 04/15/06
Criteria Supporting Features Remarks and explanations
least 20 dB above the
ambient level shall be user
selectable. A function shall
be provided to
automatically reset the
volume to the default level
after every use.
(g) Color coding shall not be
used as the only means of
conveying information,
indicating an action,
prompting a response, or
distinguishing a visual
element.
Supports
Color coding and additional means of unique identification
(e.g., text and symbols) are used.
(h) When a product permits
a user to adjust color and
contrast settings, a range of
color selections capable of
producing a variety of
contrast levels shall be
provided.
Not applicable There are no color contrast settings.
(i) Products shall be
designed to avoid causing
the screen to flicker with a
frequency greater than 2 Hz
and lower than 55 Hz.
Supports
The flash rate of any flashing elements does not fall between
2 Hz and 55 Hz.
(j) (1) Products which are
freestanding, non-portable,
and intended to be used in
one location and which
have operable controls shall
comply with the following:
The position of any
operable control shall be
determined with respect to
a vertical plane, which is 48
inches in length, centered
on the operable control,
and at the maximum
protrusion of the product
within the 48 inch length on
products which are
freestanding, non-portable,
and intended to be used in
one location and which
have operable controls.
Supports
(3) All position measurements were performed against the
specified vertical plane.
(j)(2) Products which are
freestanding, non-portable,
and intended to be used in
one location and which
have operable controls shall
comply with the following:
Where any operable control
is 10 inches or less behind
the reference plane, the
height shall be 54 inches
maximum and 15 inches
Some limitations exist The user interface is higher than 54 inches.