N connecting a monitor speaker, 18 for other, Connecting a monitor speaker – Yamaha EMX68s User Manual

Page 20

Connections

EMX88S/EMX68S—Owner’s Manual

■ When the power amp select switch is set to MAIN (L+R) BRIDGE:

• Bridge connection

Connect only one 8–16 ohm speaker to the BRIDGE jack. The speaker will output the combined signal of the
MAIN L bus + R bus. A maximum output of 800 W will be obtained when an 8-ohm speaker is used.

■ Connecting a monitor speaker

You can connect a powered speaker to the MONITOR jack.

Caution:
When using two-channel connection or two-channel parallel connection, do not connect a speaker to the
BRIDGE jack.

When using a bridge connection, do not connect a speaker to either the A or B jacks.

The BRIDGE jack has a protective cap that prevents a speaker from being accidentally connected to it when
you are using two-channel or two-channel parallel connections. Remove this protective cap only when mak-
ing a bridge connection.

Ω

–16

Ω

Power amp select switch

Not used

Powered monitor

VOL

This manual is related to the following products:

EMX88s