Yamaha EMX68s - Manual (Page 11)

EMX88S/EMX68S Quick Guide
9
EMX88S/EMX68S—Owner’s Manual
Sound output
Set the MASTER control in the MAIN section to
“
√ √ √ √ ,” then while playing an instrument con-
nected to a channel to be checked (or while
speaking to a connected microphone), adjust the
LEVEL control of the corresponding channel so
that the 0 LED of the peak level indicator in the
MAIN section will light up momentarily.
• Do not press the PAD switch if sound is input from
the microphone. Otherwise, press the PAD switch
on.
• If you are using one of the speakers as a monitor
speaker, use the MASTER control of the MONITOR
section to adjust its volume.
• Note that if the LIMITER indicator stays lit for a
long time, the built-in amplifier and speakers may
be damaged.
Applying built-in effects
1 Turn on the ON switch in the DIGITAL EFFECT
section. The ON switch indicator lights up.
2 Using the Program selector, select one of 16 effect
types.
3 Adjust the amount of effect applied by using the
EFFECT control of the target channel and the
EFFECT RTN control in the MAIN section.
Power off
1 Press the POWER switch of the EMX88S/EMX68S
to turn off the power to the unit.
2 Turn off the power to all connected devices.
• Be sure to follow the power off sequence specified
above to prevent the speakers from being dam-
aged.
• Set the MASTER controls in the MAIN section
and the MONITOR section to “0” for use next
time (so that a loud noise will not sound the next
time you turn on the power to the unit).
STEP 3
EMX88S (EMX68S)
STEP 4
EMX88S (EMX68S)
STEP 5