beautypg.com

Maintenance and cleaning, Internal cleaning, Changing the light bulb – Zanussi ZU 7115 User Manual

Page 7: When the appliance is not in use

background image

7

Before any maintenance or cleaning work is carried
out, DISCONNECT the appliance from the
ELECTRICITY supply.

Warning

This appliance contains hydrocarbons in its
cooling unit maintenance and recharging must
therefore only be carried out by authorised
technicians.

Internal cleaning

Clean the inside and accessories with warm water and
bicarbonate of soda (5ml to 0.5 litre of water). Rinse
and dry thoroughly.

NEVER USE DETERGENTS, ABRASIVE POWDERS,
HIGHLY PERFUMED CLEANING PRODUCTS OR
WAX POLISHES, TO CLEAN THE INTERIOR AS
THESE WILL DAMAGE THE SURFACE AND LEAVE
A STRONG SMELL.

Clean the drain hole of the water trough at regular
intervals and make sure that the drain hole is never
obstructed, so that the defrost water may flow freely.

Changing the light bulb

Should the interior light fail to work, first switch off the
appliance and disconnect from the electricity supply,
then replace the bulb as follows, see figure.
Unscrew the light cover and then pull it outward toward
the middle of the cabinet. Unscrew the bulb and
replace it with a new 15 watt bulb (available from your
nearest Zanussi Service Centre).

Replace the light cover by sliding it into its original
position and replacing the screw.

When the appliance is not in use

When the appliance is not in use for long periods,
disconnect from the electricity supply, empty all foods
and clean the appliance, leaving the door ajar to
prevent unpleasant smells.

D731

MAINTENANCE AND CLEANING