Zanussi ZU 7115 - Manual (Page 14)

Location
This appliance is designed to be built-in to a space
having the dimensions given in the diagram.
The height of the appliance can be altered if required
by means of adjustable feet situated at its base.
14
Door reversibility
Remove the two screws which fix the upper hinge to
the door.
Carefully lean the appliance on its back and remove
the plastic insert.
100-170
446
820-870
547 550
450
820 870
D506
D507
D447
Remove the two screws which fix the lower hinge to
the door.
Remove the four screws which fix the lower hinge to
the base of the appliance and remove the hinge
itself; be very careful to recover all the screws.
Remove the four screws that fix the upper hinge to
the appliance and remove the hinge itself.
Take the hinge removed from the upper part of the
appliance on the opposite side, and, using the
screws removed from the lower part, fix it to the base
of the appliance itself.
Remove and refit the other hinge on the upper part of
the appliance on the opposite side.
Fix the two front screws into the upper and lower
hinges.
Finally, check the alignment of the door and make
sure it closes properly.
After having reversed the opening direction of the
door, discard the original plastic insert removed and
fit the insert supplied with the appliance on the
opposite side
.
D510