Zanussi ZU 7115 - Manual (Page 15)

Fitting a decorative door panel
Import ant: The components needed to fit the
decorative panel have been pre-fitted on the
appliance.
The brackets are secured to the panel by means of
the 7 Ø 3.5x13 screws supplied. Before starting to
fit the panel, remove the large top bracket by
unscrewing the screws and adjusting pins pre-
fitted on the appliance door.
The small bottom bracket need not be removed.
Place the appliance in the position where it is to be
built in.
The appliance is fitted with adjustable feet; screw the
front and rear feet in or out to adjust the height of the
appliance to that of the recess. Keeping the appliance
central in the recess, slide it in until its back touches
the wall.
Wıth a tape measure (or similar instrument), measure
distance (A) between the top edge of the door and the
top edge of the decorative panel, placing it next to the
recess.
Lay the panel face down. Position the top bracket on
the panel, making sure that there is an equal distance
between it and the sides and that its distance from the
top edge is equal to distance (A) less 1 cm. Secure
the bracket with the screws supplied. Take care not to
damage the front face of the panel whilst working.
Insert the adjusting pins (B) into their locations in the
door and screw them in.
15
D467
= =
A
D468
A
-1cm
=
=
D532
B